Regamebox Wiki

Diese Seite ist nicht editierbar. Sie können den Quelltext sehen, jedoch nicht verändern. Kontaktieren Sie den Administrator, wenn Sie glauben, dass hier ein Fehler vorliegt.

====== Installation of Pi2Jamma Hardware ======


===== Prerequisites =====


  *     Pi2Jamma PCB
  *     Stock Audio Cable for Pi2Jamma
  *     SD Card for Raspberry Pi 16 Gbyte recommended
  *     Raspberry Pi 3 b+
  *     USB Stick otpional

The Pi2Jamma comes with a GPIO female connector and will be plugged directly on the Raspberry Pi.

The Pi2Jamma has a Jamma Interface. The Jamma harness will plugged on the Jamma connector without any modification on the cab. Parts side is the top Side.

For Audio the stock audio cable will be plugged to the audio connector of the Pi2Jamma and Raspberry Pi.

Volume control is on the black potentiometer on the Pi2Jamma. Adjust it to your needs.

Button 4, 5 for both Player is on Jamma Connector Pin 25 and 26 and bottom side. Bottom 6 for both players is available on the screw terminal. The screw terminals has also one GND.

Raspberry Pi is powered via Jamma. Again, there's no need for extra power, just Jamma interface. Raspberry Pi has over voltage protection. Its safe to use up to 5,2V

Installation steps

  *   Step 1. Insert SD card to Raspberry Pi
  *   Step 2. Insert USB Stick to Raspberry Pi optional
  *   Step 3. Plug Audio Cable to Raspberry Pi
  *   Step 4. Plug Raspberry Pi to Pi2jamma
  *   Step 5. Plug Audio Cable to Pi2jamma
  *   Step 6. Plug Pi2jamma to your Arcade Cab

You should see menu booting up. Congratulations you can now start copying your roms to the USB Stick.

Regamebox Wiki

Benutzer-Werkzeuge

Webseiten-Werkzeuge

Seiten-Werkzeuge